General purpose interface bus pdf

[jasjvxbParticipant]

.
.

General purpose interface bus pdf >> DOWNLOAD

General purpose interface bus pdf >> READ ONLINE

.
.
.
.
.
.
.
.
.
.

GPIB, HPIB Bus description, GPI Bus information, timing and General Purpose Interface Bus pin outs, IEEE488 Pinout and a Handshacking diagram to show data transfers and timing. HPIB Products are also listed.
• Assignable GPI (General Purpose Interface) port for external control and “Recording” light. This 25-pin D-sub connector provides access to the GPI (General Purpose Interface) through which external equipment can be triggered when specied 02R96 faders or USER DEFINE KEYS are operated.
The AXI IIC Bus Interface module provides the transaction interface to the AXI4-Lite interface. This core does not provide explicit electrical connectivity to the The current value of the general-purpose output field of the GPO register is reflected continuously on the GPO I/O signal of the core.
IEEE-488 General purpose interface bus and appropriate protocol are widely used in hardware-software systems for the connection of PC and work station with measurement instruments (e.g. in data acquisition systems). The protocol was developed in 60s in Hewlett-Packard and its initial name was
6.1 GPIB Control 6.1.1 Introduction The GPIB Is A Parallel Port Designed To Be Used For Communication Between Instruments Page 35 – MULTI STEP MODE Page 36 – MULTI STEP – Run Page 37 – The STATUS Page Page 38 Page 39 – GENERAL PURPOSE INTERFACE BUS (GPIB)
Purpose of External Bus Interface The majority of applications use microcontrollers in single chip configurations, that is, without any external components that would require connection The External Bus Interface is used in cases where one of the following functions is required by the application.
IEEE 488 is a short-range digital communications 8-bit parallel multi-master interface bus specification developed by Hewlett-Packard as HP-IB (Hewlett-Packard Interface Bus).
If the 2130IB bus interface module is not supplied with power any more, the bus system continues to operate. The connected controller, however, cannot be General overcurrent Short circuit, overload Earth fault Overcurrent during acceleration Overcurrent during decleration I?t monitoring I2t monitoring
The GP-IB (General Purpose Interface Bus) system is an interface that con-nects equipment such as measurement devices and computers. Even if two or more Controllers are connected to the same bus, only one of the devices can actu-ally operate as the Controller.
No Loading of Bus When Device Is Powered Down (V CC channel general-purpose interface bus transceivers are monolithic, high-speed, advanced

[Author]

Posts